Configuring Dynamic Mode - HP FlexNetwork MSR Series Configuration Manual

Step
2. Create a frame relay class
and enter frame relay class
view.
3. Reserve a bandwidth for
voice.
4. Exit frame relay class view.
5. Enter frame relay interface
view
6. Associate the frame relay
class with a frame relay
interface or virtual circuit.
For more information about the frame relay class operations, see HPE FlexNetwork MSR Router
Series Comware 5 ACL and QoS Configuration Guide and Layer 2—WAN Configuration Guide.
The bandwidth occupied by a call is related to the codec.
the codecs supported by VoFR.
Table 17 Voice bandwidths required for different codecs
Codec
G.729R8 and G.729A
G.711A-law and G.711μ-law
G.723R63
G.723R53

Configuring dynamic mode

This section describes the procedure for configuring dynamic mode call flow.
Command
fr class class-name
voice bandwidth reserved-bps [ reserved ]
quit
interface serial interface-number
•
Associate the frame relay class with a
frame relay interface so that the settings of
voice bandwidth can take effect on the
frame relay interface:
fr-class class-name
•
Associate the frame relay class with a
frame relay virtual circuit:
a. Enter interface DLCI view
fr dlci dlci-number
b. Associate the frame relay class with a
frame relay virtual circuit so that the
settings of voice bandwidth can take
effect on the DLCI
fr-class class-name
Bandwidth (kbps)
10
67
9
8
315
Remarks
N/A
By default, no
bandwidth is reserved
for voice.
N/A
N/A
Use either method.
By default, no frame
relay class is
associated with a
frame relay interface
or virtual circuit.
Table 17
lists the bandwidths required for