Configuring Pri; Configuring Dss1 And Qsig Signaling - HP FlexNetwork MSR Series Configuration Manual

Step
9. Adopt Group B signals to
complete interregister
signaling exchange.
10. Enable this end to send a
number terminator to the
terminating side.
11. Configure the special
characters that are
supported during
interregister signaling
exchange.
12. Configure register signal
values in R2 signaling.
13. Configure the duration of
register pulse signals such
as A-3, A-4, and A-6 in R2
signaling.
14. Configure the maximum time
waiting for a Group B signal.

Configuring PRI

This section describes how to configure DSS1 and QSIG signaling and how to enable the
transmission of QSIG signaling over a SIP network.

Configuring DSS1 and QSIG signaling

After you create a PRI group with the pri-set command on an E1/T1 interface, a serial interface is
automatically created. This interface is named serial number:15 on an E1 interface and serial
number:23 on a T1 interface. You can enter the view of the interface with the interface serial
number:{ 15 | 23 } command to configure DSS1 and QSIG user signaling.
To configure DSS1 or QSIG signaling:
Command
group-b enable
final-callednum enable
special-character character
number
register-value { billingcategory
| callcreate-in-groupa |
callingcategory | congestion |
demand-refused | digit-end |
nullnum | req-billingcategory |
req-callednum-and-switchgrou
pa | req-callingcategory | req-
currentcallednum-in-groupc |
req-currentdigit | req-
firstcallednum-in-groupc |
req-firstcallingnum |
req-firstdigit | req-lastfirstdigit |
req-lastseconddigit |
req-lastthirddigit |
req-nextcallednum |
req-nextcallingnum |
req-switch-groupb |
subscriber-abnormal
|subscriber-busy |
subscriber-charge
|subscriber-idle } value
timer register-pulse
persistence time
timer register-complete
group-b time
81
Remarks
Optional.
Group B signals are used by
default.
Optional.
Disabled by default.
Optional.
No special character is configured
by default.
Optional.
The defaults vary by country
mode.
Optional.
The default is 150 milliseconds.
Optional.
The default is 30,000
milliseconds.