Igmp Snooping Configuration Examples; Group Policy And Simulated Joining Configuration Example - HP MSR2003 Configuration Manual

Task
Remove the dynamic IGMP snooping forwarding
entries for the specified multicast groups.
Remove dynamic router ports.
Clear statistics for the IGMP messages learned by
IGMP snooping.

IGMP snooping configuration examples

Group policy and simulated joining configuration example

Network requirements
As shown in
snooping.
Configure a group policy and simulated joining to meet the following requirements:
• Host A and Host B receive only the multicast data addressed to the multicast group 224.1.1.1.
Multicast data can be forwarded through GigabitEthernet 2/1/3 and GigabitEthernet 2/1/4 of
•
Switch A uninterruptedly, even though Host A and Host B fail to receive the multicast data.
Switch A will drop unknown multicast data instead of flooding it in VLAN 100.
•
Figure 12 Network diagram
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. Configure Router A:
# Enable IP multicast routing.
<RouterA> system-view
Figure 12, Router A runs IGMPv2 and serves as the IGMP querier. Switch A runs IGMPv2
Command
reset igmp-snooping group { group-address
[ source-address ] | all } [ vlan vlan-id ]
reset igmp-snooping router-port { all | vlan vlan-id }
reset igmp-snooping statistics
31
Figure 12. (Details not