Displaying And Maintaining Voice Vlan; Voice Vlan Configuration Examples; Automatic Voice Vlan Mode Configuration Example - HP A6600 Configuration Manual

To do...
8. Enable voice VLAN on the
port
Configure different voice VLANs on different ports at the same time. However, one port can be
configured with only one voice VLAN, and this voice VLAN must be a static VLAN that already exists on
the router.
Voice VLAN cannot be enabled on a port with LACP enabled.
To make voice VLAN take effect on a port that is enabled with voice VLAN and operates in manual voice
VLAN assignment mode, you need to assign the port to the voice VLAN manually.

Displaying and maintaining voice VLAN

To do...
Display the voice VLAN state
Display the OUI addresses
supported by system

Voice VLAN configuration examples

Automatic voice VLAN mode configuration example

Network requirements
As shown in
• The MAC address of IP phone A is 0011-1100-0001. The phone connects to a downstream device
named PC A whose MAC address is 0022-1100-0002 and to GigabitEthernet 4/1/1 on an
upstream device named Router A.
The MAC address of IP phone B is 0011-2200-0001. The phone connects to a downstream device
•
named PC B whose MAC address is 0022-2200-0002 and to GigabitEthernet 4/1/2 on Router A.
Router A uses voice VLAN 2 to transmit voice packets for IP phone A and voice VLAN 3 to transmit
•
voice packets for IP phone B.
Configure GigabitEthernet 4/1/1 and GigabitEthernet 4/1/2 to work in automatic voice VLAN
•
assignment mode. In addition, if one of them has not received any voice packet in 30 minutes, the
port is removed from the corresponding voice VLAN automatically.
Use the command...
voice vlan vlan-id enable
Use the command...
display voice vlan state [ | { begin | exclude
| include } regular-expression ]
display voice vlan oui [ | { begin | exclude |
include } regular-expression ]
Figure 41,
Required.
126
Remarks
Remarks
Available in any view
Available in any view