Creating, Storing, And Performing Operations On Configuration Lists And Points; Using The Front Panel For Configuration List Operations - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
Creating, storing, and performing operations on configuration lists
and points
To create a configuration point, you need to:
•
Create a new configuration list and give it a name or use a specific configuration list that already
exists on the instrument
•
Configure the instrument with the settings that you want to store in a configuration point
•
Store the active settings into a configuration point on the specified configuration list
After you store configuration points to a configuration list, you can perform the following operations on
a specific configuration point:
•
Recall a configuration point and restore the stored settings to the active state
•
View the contents of a configuration point
•
Delete a configuration point or delete the entire configuration list
You can perform configuration lists operations from the front panel (see
configuration list operations
commands for configuration list operations

Using the front panel for configuration list operations

This section describes how to store the active settings to a specific point on a configuration list.
See What is a configuration point?
configuration points to configuration lists before reading this section.
The following topics provide information to:
•
Create an example measure configuration list named MyMeasList.
•
Store two example configuration points on MyMeasList. The following table provides information
about specific settings for each configuration point.
•
View the contents of a specific configuration point.
•
Recall a configuration point from MyMeasList.
This example creates a measure configuration list; however, you can use the same process to create
a source configuration list.
Front panel configuration list menu overview
To display the configuration list menus from the main menu:
1. Press the MENU key.
2. Under Measure, select Config List. The MEASURE CONFIGURATION LISTS screen is
displayed. Use this menu for operations on measure configuration lists.
3. Under Source, select Config List. The SOURCE CONFIGURATION LISTS screen is displayed.
Use this menu for operations on source configuration lists.
2450-901-01 Rev. B/September 2013
(on page 3-39)) or by using remote commands (see
(on page 3-43).
(on page 3-35) for information about how the instrument adds
Section 3: Functions and features
Using the front panel for
Using remote
3-39