Trigger:digital<N>:Out:stimulus - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
:TRIGger:DIGital<n>:OUT:STIMulus
This command selects the event that causes a trigger to be asserted on the digital output line.
Type
Command and query
Usage
:TRIGger:DIGital<n>:OUT:STIMulus <event>
:TRIGger:DIGital<n>:OUT:STIMulus?
<n>
<event>
Details
The digital trigger pulsewidth command determines how long the trigger is asserted. The trigger stimulus for a
digital I/O line may be set to one of the existing trigger events, which are described in the following table.
Trigger events
Event description
No trigger event
Front-panel TRIGGER key press
Notify trigger block <n> (1 to 8) generates a trigger event
when the trigger model executes it
A command interface trigger occurred:
Any remote interface: *TRG
•
GPIB only: GET bus command
•
VXI-11: VXI-11 command device_trigger
•
Line edge (either rising, falling, or either based on the
configuration of the line) detected on digital input line
<n> (1 to 6)
Line edge detected on TSP-Link synchronization
line <n> (1 to 3)
Appropriate LXI trigger packet is received on LAN trigger
object <n> (1 to 8)
Trigger event blender <n> (1 to 2), which combines
trigger events
Trigger timer <n> (1 to 4) expired
Source limit condition occurs
Example
:TRIG:DIG2:OUT:STIMulus TIM3
Also see
:DIGital:LINE<n>:STATe
:TRIGger:DIGital<n>:OUT:LOGic
Digital I/O port
2450-901-01 Rev. B/September 2013
Affected by
Recall settings
Instrument reset
Power cycle
Digital I/O trigger line (1 to 6)
The event to use as a stimulus; see Details
(on page 6-20)
(on page 6-151)
(on page 3-62)
Section 6: SCPI command reference
Where saved
Save settings
Event constant
NONE
DISPlay
NOTify<n>
COMMand
DIGio<n>
TSPLink<n>
LAN<n>
BLENder<n>
TIMer<n>
SLIMit
Set the stimulus for output digital trigger line
2 to be the expiration of trigger timer 3.
Default value
NONE
6-153