Model 2450 Interactive SourceMeter® Instrument Reference Manual
*STB?
This command gets the serial poll byte of the instrument without clearing the request service bit.
Type
Query only
Usage
*STB?
Details
The status byte query (*STB?) command is similar to a serial poll, but it is processed like any other instrument
command.
The *STB? command returns the same result as a serial poll, but the request service bit (bit 6) is not cleared if a
serial poll has occurred.
Example
*STB?
Also see
None
*TRG
This command generates a trigger event from a remote command interface.
Type
Command only
Usage
*TRG
Details
Use the *TRG command to generate a trigger event.
If you are using the SCPI command set, this command generates the COMMAND event. If you are using the
TSP command set, this command generates the trigger.EVENT_COMMAND event. You can use this constant
as the stimulus of any trigger object, which causes that trigger object to respond to the trigger events generated
by *TRG. See
Also see
:INITiate[:IMMediate]
2450-901-01 Rev. B/September 2013
Affected by
Not applicable
Affected by
Using trigger events to start actions in the trigger model
(on page 6-124)
Where saved
Not applicable
Queries the status byte.
Where saved
(on page 3-109).
Appendix B: Common commands
Default value
Not applicable
Default value
B-9