Keithley 2450 Reference Manual page 273

Section 3: Functions and features
Remote TSP-Link commands
Commands that control and access the TSP-Link
following table. See the
commands.
Use the commands in following table to perform basic steady-state digital I/O operations; for example,
you can program the Model 2450 to read and write to a specific TSP-Link synchronization line or to
the entire port.
TSP-Link commands
Command
trigger.tsplinkin[N].clear()
trigger.tsplinkin[N].edge
trigger.tsplinkin[N].overrun
trigger.tsplinkin[N].wait()
trigger.tsplinkout[N].assert()
trigger.tsplinkout[N].logic
trigger.tsplinkout[N].pulsewidth
228)
trigger.tsplinkout[N].release()
trigger.tsplinkout[N].stimulus
tsplink.group (on page 8-230)
tsplink.initialize()
tsplink.line[N].mode
tsplink.line[N].reset()
tsplink.line[N].state
tsplink.master
tsplink.node (on page 8-234)
tsplink.readport()
tsplink.state (on page 8-235)
tsplink.writeport()
3-128
TSP command reference
(on page 8-224)
(on page 8-225)
(on page 8-226)
(on page 8-226)
(on page 8-227)
(on page 8-228)
(on page 8-
(on page 8-229) Releases a latched trigger on the given TSP-Link
(on page 8-229) Specifies the event that causes the
(on page 8-231)
(on page 8-232)
(on page 8-233)
(on page 8-233)
(on page 8-234)
(on page 8-235)
(on page 8-236)
Model 2450 Interactive SourceMeter® Instrument Reference Manual
®
synchronization port are summarized in the
(on page 8-1) for complete details on these
Description
Clears the event detector for a trigger
Indicates which trigger edge controls the trigger
event detector for a trigger line
Indicates if the event detector ignored an event
while in the detected state
Waits for a trigger
Simulates the occurrence of the trigger and
generates the corresponding trigger event
Defines the trigger output with output logic for a
trigger line
Sets the length of time that the trigger line is
asserted for output triggers
trigger line
synchronization line to assert a trigger
The group number of the TSP-Link node
Initializes all instruments and enclosures in the
TSP-Link system
Defines the trigger operation of a TSP-Link line
as digital in or out or trigger in or out
Resets some of the TSP-Link trigger attributes to
their defaults
Reads or writes the digital state of a TSP-Link
synchronization line
Reads the node number assigned to the master
node
Defines the node number
Reads the TSP-Link synchronization lines as a
digital I/O port
Describes the TSP-Link online state
Writes to all TSP-Link synchronization lines as a
digital I/O port
2450-901-01 Rev. B/September 2013