Smu.source.xlimit.tripped - Keithley 2450 Reference Manual

Section 8: TSP command reference

smu.source.xlimit.tripped

This attribute indicates if the source exceeded the limits that were set for the selected measurements.
Type TSP-Link accessible
Attribute (R) Yes
Usage
state = smu.source.xlimit.tripped
state
x
Details
You can use this command check the limit state of the source.
If the limits were exceeded, the instrument clamps the source to keep the source within the set limits.
If you check the limit for the source that is not presently selected, nil is returned.
Example
print(smu.source.vlimit.tripped)
Also see
smu.source.xlimit.level
8-138
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Affected by
Function change
Indicates if limit has been tripped:
Not tripped: smu.OFF
•
Tripped: smu.ON
•
The function whose limit was tripped:
v: voltage
•
i: current
•
(on page 8-137)
Where saved Default value
Not saved Not applicable
Check the state of the source limit for
voltage. If the limit was exceeded, the output
is:
smu.ON
2450-901-01 Rev. B/September 2013