Smu.measure.terminals - Keithley 2450 Reference Manual

Section 8: TSP command reference

smu.measure.terminals

This command determines which set of input and output terminals the instrument is using.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
terminals = smu.measure.terminals
smu.measure.terminals = terminals
terminals
Details
This command selects which set of input and output terminals the instrument uses. You can select front panel or
rear panel terminals.
If the output is turned on when you change from one set of terminals to the other, the output is turned off.
Example
smu.measure.terminals = smu.TERMINALS_FRONT Use the front-panel terminals for measurements.
Also see
None
8-124
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Affected by
Restore configuration
Instrument reset
Power cycle
Measure configuration list
Use the front-panel input and output terminals: smu.TERMINALS_FRONT
Use the rear-panel input and output terminals: smu.TERMINALS_REAR
Where saved Default value
Configuration script smu.TERMINALS_FRONT
Measure configuration list
2450-901-01 Rev. B/September 2013