Trace:trigger; Trigger Subsystem; Initiate[:Immediate] - Keithley 2450 Reference Manual

Section 6: SCPI command reference

:TRACe:TRIGger

This command makes readings and stores them in a buffer.
Type
Command only
Usage
:TRACe:TRIGger
:TRACe:TRIGger <bufferName>
<bufferName>
Details
Makes readings and stores them in the specified buffer.
Example
TRACe:MAKE "MyBuffer", 100
TRACe:TRIG "MyBuffer"
TRACe:TRIG "MyBuffer"
TRACe:TRIG "MyBuffer"
TRACe:TRIG "MyBuffer"
TRACe:TRIG "MyBuffer"
TRACe:DATA? 1,5, "MyBuffer", rel
Also see
:TRACe:MAKE

TRIGger subsystem

The commands in this subsystem configure and control the trigger operations, including the trigger
model.

:INITiate[:IMMediate]

This command starts the trigger model.
Type
Command
Usage
:INITiate[:IMMediate]
Also see
Trigger model
6-124
Affected by
Not applicable
A string that indicates the reading buffer; the default buffers
(defbuffer1 or defbuffer2) or the name of a user-defined buffer; if no
buffer is specified, this parameter defaults to defbuffer1
(on page 6-114)
Affected by
Not applicable
(on page 3-95)
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Where saved
Not applicable
Create a buffer called MyBuffer with a maximum size of
100.
Take readings and store them in MyBuffer.
Recall the relative time when the data points were
measured for the first five readings in the buffer.
Example output:
0.000000,0.408402,0.816757,1.208823,1.6175
29
Where saved
Not applicable
Default value
Not applicable
Default value
Not applicable
2450-901-01 Rev. B/September 2013