Trigger:timer<N>:Start:fractional - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
:TRIGger:TIMer<n>:STARt:FRACtional
This command configures an alarm or a time in the future when the timer will start.
Type
Command and query
Usage
:TRIGger:TIMer<n>:STARt:FRACtional <time>
:TRIGger:TIMer<n>:STARt:FRACtional?
<n>
<time>
Details
This command configures the alarm of the timer.
When the timer is enabled, the timer starts immediately if the timer is configured for a start time in the past or if it
is in the future.
Example
TRIG:TIM1:STAR:SEC 60
TRIG:TIM1:START:FRAC 0.5
TRIG:TIM2:STAT ON
Also see
:TRIGger:TIMer<n>:STARt:SEConds
:TRIGger:TIMer<n>:STATe
2450-901-01 Rev. B/September 2013
Affected by
Recall settings
Instrument reset
Power cycle
The trigger timer number (1 to 4)
The time in seconds (0 to 2147483647)
(on page 6-171)
(on page 6-173)
Section 6: SCPI command reference
Where saved
Save settings
Set the timer for 60.5 seconds.
Enable the trigger timer for timer 3.
Default value
0
6-169