Source[1]:<Function>:Delay:user<N - Keithley 2450 Reference Manual

Section 6: SCPI command reference
:SOURce[1]:<function>:DELay:USER<n>
This command sets a user-defined delay that can be used in the trigger model.
Type
Command and query
Usage
:SOURce[1]:<function>:DELay:USER<n> <delayTime>
:SOURce[1]:<function>:DELay:USER<n>?
:SOURce[1]:<function>:DELay:USER<n>? DEFault
:SOURce[1]:<function>:DELay:USER<n>? MAXimum
:SOURce[1]:<function>:DELay:USER<n>? MINimum
<function>
<n>
<delayTime>
Details
To use this commands in a trigger model, assign the delay to the dynamic delay block.
Example
:SOUR:VOLT:DEL:USER1 5
:TRIG:BLOC:SOUR:STAT 1, ON
:TRIG:BLOC:DEL:DYN 2, SOUR1
:TRIG:BLOC:MEAS 3
:TRIG:BLOC:SOUR:STAT 4, OFF
:TRIG:BLOC:BRAN:COUN 5, 10, 1
:INIT
Also see
:TRIGger:BLOCk:DELay:DYNamic
6-68
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Affected by
Recall settings
Instrument reset
Power cycle
Source configuration list
The source function to which this setting applies:
Current: CURRent
•
Voltage: VOLTage
•
The number that identifies this user delay (1 to 5)
The time of the delay in seconds (0 to 10,000)
(on page 6-140)
Where saved
Save settings
Source configuration list
Set user delay for source 1 to 5 seconds.
Set trigger block 1 to turn the source output on.
Set trigger block 2 to a dynamic delay that calls
source user delay 1.
Set trigger block 3 to make a measurement.
Set trigger block 4 to turn the source output off.
Set trigger block 5 to branch to block 1 ten times.
Start the trigger model.
2450-901-01 Rev. B/September 2013
Default value
0.000000E+00