Trigger:lan<N>:In:edge - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
:TRIGger:LAN<n>:IN:EDGE
This command sets the trigger operation and detection mode of the specified LAN event.
Type
Command and query
Usage
:TRIGger:LAN<n>:IN:EDGE <mode>
:TRIGger:LAN<n>:IN:EDGE?
<n>
<mode>
Details
This attribute controls the mode in which the trigger event detector and the output trigger generator operate on
the given trigger. These settings are intended to provide behavior similar to the digital I/O triggers.
LAN trigger mode values
Mode
EITHer
FALLing
RISing
Example
:TRIG:LAN2:IN:EDGE FALL
Also see
Digital I/O
TSP-Link System Expansion Interface
2450-901-01 Rev. B/September 2013
Affected by
LAN trigger <n> reset
Recall settings
The LAN event number (1 to 8)
The trigger mode; see the Details for more information
Trigger packets detected as input
Rising or falling edge (positive or negative state)
Falling edge (negative state)
Rising edge (positive state)
(on page 3-62)
Where saved
Save settings
Nonvolatile memory
LAN trigger packet generated for output with a...
negative state
negative state
positive state
Set the LAN trigger mode for event 2 to falling.
(on page 3-118)
Section 6: SCPI command reference
Default value
EITH
6-155