Trigger:timer<N>:Count - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
Details
This command sets the timer event detector to the undetected state and resets the overrun indicator.
Example
:TRIG:TIM1:CLEar
Also see
:TRIGger:TIMer<n>:COUNt
:TRIGger:TIMer<n>:STARt:OVERrun?
:TRIGger:TIMer<n>:COUNt
This command sets the number of events to generate each time the timer detects its trigger event or is enabled as
a timer or alarm.
Type
Command and query
Usage
TRIGger:TIMer<n>:COUNt <count>
TRIGger:TIMer<n>:COUNt?
<n>
<count>
Details
If count is set to a number greater than 1, the timer automatically starts the next delay at the expiration of the
previous delay.
Set count to zero (0) to cause the timer to generate trigger events indefinitely.
This command should not be used with the trigger model.
Example
TRIG:TIM2:COUN 4
Also see
None
2450-901-01 Rev. B/September 2013
(on page 6-167)
(on page 6-170)
Affected by
Recall settings
Instrument reset
Power cycle
A trigger timer number (1 to 4)
The number of times to repeat the trigger
Section 6: SCPI command reference
Clears trigger timer 1.
Where saved
Save settings
Set the number of events to generate for
trigger timer 2 to four.
Default value
1
6-167