Buffervar.times - Keithley 2450 Reference Manual

Section 8: TSP command reference
Example
reset()
testData = buffer.make(50)
smu.source.output = smu.ON
trigger.model.load("SimpleLoop", 2, 0, testData)
trigger.model.initiate()
waitcomplete()
printbuffer(1, 2, testData.statuses)
Also see
buffer.make()
bufferVar.clear()
buffer.delete()
print() (on page 8-77)
printbuffer() (on page 8-78)
Reading buffers
Remote buffer operation

bufferVar.times

This attribute contains the time when the instrument made the readings.
Type TSP-Link accessible
Attribute (R) Yes
Usage
readingTime = bufferVar.dates[N]
readingTime
bufferVar
N
Details
This attribute contains the time when the instrument made the readings.
8-34
(on page 8-11)
(on page 8-17)
(on page 8-9)
(on page 3-10)
(on page 3-27)
Affected by
Restore configuration
Instrument reset
Power cycle
Hours, minutes, and seconds
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer
The reading number N; can be any value between 1 and the number of readings in
the buffer; use the bufferVar.n command to determine the number of readings
in the buffer
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Create a reading buffer named testData,
configure the instrument to make two
measurements, and store the readings in
the buffer.
Turn on the source output.
Print the source status for the readings in
testData.
Output:
128, 128
Indicating that the status is
buffer.STAT_OUTPUT.
Where saved
Not applicable
Default value
Not applicable
2450-901-01 Rev. B/September 2013