Calculate2:<Function>:Limit<Y>:Clear[:Immediate] - Keithley 2450 Reference Manual

Section 6: SCPI command reference
:CALCulate2:<function>:LIMit<Y>:CLEar[:IMMediate]
This command clears the results of the limit test.
Type
Command only
Usage
:CALCulate2:<function>:LIMit<Y>:CLEar[:IMMediate]
<function>
<y>
Details
Use this command to clear the test results of limit Y when the limit auto clear command is disabled. Both the high
and low test results are cleared.
To avoid the need to manually clear the test results for a limit, enable the auto clear command.
If you send this command without the <function> parameter, it will set the limit for all functions.
Example
calc2:curr:lim1:clear
Also see
:CALCulate2:<function>:LIMit<Y>:LOWer[:DATA]
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA]
6-14
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Affected by
Not applicable
The function to which this setting applies:
•
•
•
The limit that the setting applies to, 1 or 2
Where saved
Not applicable
Current: CURRent[:DC]
Resistance: RESistance
Voltage: VOLTage[:DC]
Clear the results for limit test 1.
(on page 6-16)
(on page 6-18)
Default value
Not applicable
2450-901-01 Rev. B/September 2013