Calculate2:<Function>:Limit<Y>:State - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
:CALCulate2:<function>:LIMit<Y>:STATe
This command enables or disables a limit test.
Type
Command and query
Usage
:CALCulate2:<function>:LIMit<Y>:STATe <b>
:CALCulate2:<function>:LIMit<Y>:STATe?
<function>
<Y>
<b>
Details
This command enables or disables a limit test for the selected measurement function.
If you send this command without the <function> parameter, it will set the state of math operations
for all functions.
Example
CALC2:VOLT:LIM1:LOW 0.25
CALC2:VOLT:LIM1:UPP 2.5
CALC2:VOLT:LIMIT1:STAT ON
CALC2:VOLT:LIMIT1:FAIL?
Also see
None
2450-901-01 Rev. B/September 2013
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which this setting applies:
•
•
•
The limit that the setting applies to, 1 or 2
Enable the limit test: 1 or ON
Disable the limit test: 0 or OFF
Where saved
Save settings
Measure configuration list
Current: CURRent[:DC]
Resistance: RESistance
Voltage: VOLTage[:DC]
Set lower limit 1 for voltage to 0.25 volts.
Set upper limit 1 for voltage to 2.5 volts.
Enable limit 1 testing for voltage.
Check the test results.
Section 6: SCPI command reference
Default value
0 (OFF)
6-17