Trigger:lan<N>:Out:ip:address; Trigger:lan<N>:Out:logic - Keithley 2450 Reference Manual

Section 6: SCPI command reference
:TRIGger:LAN<n>:OUT:IP:ADDRess
This command specifies the address (in dotted-decimal format) of UDP or TCP listeners.
Type
Command and query
Usage
:TRIGger:LAN<n>:OUT:IP:ADDRess <address>
:TRIGger:LAN<n>:OUT:IP:ADDRess?
<n>
<address>
Details
Sets the IP address for outgoing trigger events.
After you change this setting, you must send the connect command before outgoing messages can be sent.
Example
TRIG:LAN1:OUT:IP:ADDR "192.0.32.10"
Also see
:TRIGger:LAN<n>:OUT:CONNect:STATe
:TRIGger:LAN<n>:OUT:LOGic
This command sets the logic on which the trigger event detector and the output trigger generator operate on the
given trigger line.
Type
Command and query
Usage
:TRIGger:LAN<n>:OUT:LOGic <logicType>
:TRIGger:LAN<n>:OUT:LOGic?
<n>
<logicType>
Example
TRIG:LAN1:OUT:LOG POS
Also see
None
6-158
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Affected by
Recall settings
Instrument reset
Power cycle
The LAN event number (1 to 8)
A string that represents the LAN address in dotted decimal notation
(on page 6-157)
Affected by
Not applicable
The LAN event number (1 to 8)
POSitive
NEGative
Where saved
Save settings
Use IP address 192.0.32.10 to connect the
LAN trigger.
Where saved
Nonvolatile memory
Set the logic to positive.
2450-901-01 Rev. B/September 2013
Default value
"0.0.0.0"
Default value
NEG