Smu.measure.limit[Y].Low.value - Keithley 2450 Reference Manual

Section 8: TSP command reference

smu.measure.limit[Y].low.value

This command specifies the lower limit for limit tests.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
value = smu.measure.limit[Y].low.value
smu.measure.limit[Y].low.value = value
value
Y
Details
This command sets the lower limits for the limit tests for the selected measurement function. When limit Y testing
is enabled, this causes a fail indication to occur when the measurement value is less than this value.
Example
See the example in
Also see
smu.measure.limit[Y].enable
8-110
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Affected by
Restore configuration
Instrument reset
Power cycle
Measure configuration list
Function change
The high value; range is −999999900000 to +999999900000
Limit number: 1 or 2
smu.measure.limit[Y].fail (on page 8-107).
(on page 8-106)
Where saved Default value
Configuration script
−1.000000E+00
Measure configuration list
2450-901-01 Rev. B/September 2013