Trace:make - Keithley 2450 Reference Manual

Section 6: SCPI command reference

:TRACe:MAKE

This command creates a user-defined reading buffer.
Type
Command only
Usage
:TRACe:MAKE <bufferName>, <bufferSize>
<bufferName>
<bufferSize>
Details
This command creates a user-defined reading buffer.
You cannot assign user-defined reading buffers the same name as an existing buffer, including defbuffer1 or
defbuffer2.
Example
TRACe:MAKE "capTrace", 200
Also see
Reading buffers
Remote buffer operation
:TRACe:MAKE
6-114
Affected by
Recall settings
Instrument reset
Power cycle
A user-supplied string that indicates the name of a user-defined buffer
A number that indicates the maximum number of readings that can be stored in
<bufferName>; minimum is 10
(on page 3-10)
(on page 3-27)
(on page 6-114)
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Where saved
Saved setup
This example creates a 200-element reading buffer
named capTrace.
Default value
Not applicable
2450-901-01 Rev. B/September 2013