Trigger:block:log:event - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual

:TRIGger:BLOCk:LOG:EVENt

This command logs an event during trigger model execution.
Type
Command only
Usage
TRIGger:BLOCk:LOG:EVENt <blockNumber>, <eventNumber>, <message>
<blockNumber>
<eventNumber>
<message>
Details
This block allows you to log an event in the event log when the trigger model is running. Insert the block into the
trigger model. When the trigger model executes the block, the event is logged.
Note that using this block too often in a trigger model could overflow the event log. It may also take away from
the time needed to process more critical trigger model blocks.
Also see
None
2450-901-01 Rev. B/September 2013
Affected by
Recall settings
Instrument reset
Power cycle
The sequence of the block in the trigger model
The event number:
INFO<n>
•
WARNing<n>
•
ERRor<n>
•
Where <n> is 1 to 4; you can define up to four of each type
A string up to 32 characters
Section 6: SCPI command reference
Where saved
Save settings
Default value
Not applicable
6-143