Buffervar.sourceunits - Keithley 2450 Reference Manual

Section 8: TSP command reference
Example
reset()
testData = buffer.make(50)
smu.source.output = smu.ON
trigger.model.load("SimpleLoop", 2, 0, testData)
trigger.model.initiate()
waitcomplete()
printbuffer(1, 2, testData.sourcestatuses)
Also see
buffer.make()
bufferVar.clear()
buffer.delete()
print() (on page 8-77)
printbuffer() (on page 8-78)
Reading buffers
Remote buffer operation

bufferVar.sourceunits

This attribute contains the units of measure of the source.
Type TSP-Link accessible
Attribute (R) Yes
Usage
readingUnits = bufferVar.sourceunits[N]
readingUnits
bufferVar
N
8-30
(on page 8-11)
(on page 8-17)
(on page 8-9)
(on page 3-10)
(on page 3-27)
Affected by
Restore configuration
Instrument reset
Power cycle
The units of measure of the source:
Volt DC
•
Amp DC
•
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer
The reading number N; can be any value between 1 and the number of readings in the
buffer; use the bufferVar.n command to determine the number of readings in the
buffer
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Create a reading buffer named
testData, configure the instrument to
make two measurements, and store the
readings in the buffer.
Turn on the source output.
Print the source status for the readings
in testData.
Output:
128, 128
Indicating that the status is
buffer.STAT_OUTPUT.
Where saved
Not applicable
Default value
Not applicable
2450-901-01 Rev. B/September 2013