[:Sense[1]]:Configuration:list:store - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
Details
This command returns the size (number of configuration points) of a measure configuration list..
The size of the list is equal to the number of configuration points in a configuration list.
Examples
:SENSe:CONF:LIST:SIZE? "MyMeasList"
Also see
Configuration lists
[:SENSe[1]]:CONFiguration:LIST:CREate

[:SENSe[1]]:CONFiguration:LIST:STORe

This command stores the active measure settings into the named configuration list.
Type
Command only
Usage
[:SENSe[1]]:CONFiguration:LIST:STORe <name>
[:SENSe[1]]:CONFiguration:LIST:STORe <name>, <point>
<name>
<point>
Details
Use this command to store the active settings to a configuration point in a configuration list. If you do not include
the <point> parameter, the configuration point will append to the end of the list.
Refer to Instrument settings stored in a measure configuration list
settings that the instrument stores in a measure configuration list.
Example
:SENSe:CONF:LIST:STOR "MyConfigList"
:SENSe:CONF:LIST:STOR "MyConfigList", 5
Also see
Configuration lists
[:SENSe[1]]:CONFiguration:LIST:CREate
2450-901-01 Rev. B/September 2013
(on page 3-33)
(on page 6-37)
Affected by
Recall settings
Instrument reset
Power cycle
A string that represents the name of a measure configuration list
A specific configuration point in the configuration list
(on page 3-33)
(on page 6-37)
Section 6: SCPI command reference
Returns the number of configuration points in
a measure configuration list named
MyMeasList.
Where saved
Saved settings
(on page 3-36) for a complete list of measure
Stores the active settings of the instrument to the
end of the configuration list named
MyConfigList.
Stores the active settings of the instrument to the
configuration list named MyConfigList in
configuration point 5.
Default value
Not applicable
6-41