Keithley 2450 Reference Manual page 477

Section 6: SCPI command reference
Details
This attribute specifies which event causes a LAN trigger packet to be sent for this trigger. Set the event to one
of the existing trigger events, which are shown in the following table.
Setting this attribute to none disables automatic trigger generation.
If any events are detected before the trigger LAN connection is sent, the event is ignored and the action overrun
is set.
Trigger events
Event description
No trigger event
Front-panel TRIGGER key press
Notify trigger block <n> (1 to 8) generates a trigger event
when the trigger model executes it
A command interface trigger occurred:
Any remote interface: *TRG
•
GPIB only: GET bus command
•
VXI-11: VXI-11 command device_trigger
•
Line edge (either rising, falling, or either based on the
configuration of the line) detected on digital input line
<n> (1 to 6)
Line edge detected on TSP-Link synchronization
line <n> (1 to 3)
Appropriate LXI trigger packet is received on LAN trigger
object <n> (1 to 8)
Trigger event blender <n> (1 to 2), which combines
trigger events
Trigger timer <n> (1 to 4) expired
Source limit condition occurs
Example
TRIG:LAN1:OUT:STIM TIM1
Also see
:TRIGger:LAN<n>:OUT:CONNect:STATe
6-160
Model 2450 Interactive SourceMeter® Instrument Reference Manual
Event constant
NONE
DISPlay
NOTify<n>
COMMand
DIGio<n>
TSPLink<n>
LAN<n>
BLENder<n>
TIMer<n>
SLIMit
Set the timer 1 trigger event as the source for the
LAN packet 1 trigger stimulus.
(on page 6-157)
2450-901-01 Rev. B/September 2013