Trigger:lan<N>:Out:protocol; Trigger:lan<N>:Out:stimulus - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
:TRIGger:LAN<n>:OUT:PROTocol
This command sets the LAN protocol to use for sending trigger messages.
Type
Command and query
Usage
:TRIGger:LAN<n>:OUT:PROTocol
:TRIGger:LAN<n>:OUT:PROTocol?
<n>
<protocol>
Details
The LAN trigger listens for trigger messages on all the supported protocols. However, it uses the designated
protocol for sending outgoing messages.
After you change this setting, you must re-connect the LAN trigger event generator before you can send outgoing
event messages.
When multicast is selected, the trigger IP address is ignored and event messages are sent to the multicast
address 224.0.23.159.
Example
:TRIG:LAN1:OUT:PROT TCP
:TRIG:LAN1:OUT:CONN:STAT
Also see
:TRIGger:LAN<n>:OUT:CONNect:STATe
:TRIGger:LAN<n>:OUT:IP:ADDRess
:TRIGger:LAN<n>:OUT:STIMulus
This command specifies events that cause this trigger to assert.
Type
Command and query
Usage
:TRIGger:LAN<n>:OUT:STIMulus <eventID>
:TRIGger:LAN<n>:OUT:STIMulus?
<n>
<eventID>
2450-901-01 Rev. B/September 2013
Affected by
Recall settings
Instrument reset
Power cycle
The LAN event number (1 to 8)
The protocol to use for messages from the trigger:
• TCP
• UDP
• MULTicast
(on page 6-157)
(on page 6-158)
Affected by
Recall settings
Instrument reset
Power cycle
A number specifying the trigger packet over the LAN for which to set or query the
trigger source (1 to 8)
The LAN event identifier used to trigger the event
Section 6: SCPI command reference
Where saved
Save settings
Set the LAN protocol for trigger messages to be
TCP and re-connect the LAN trigger event
generator.
Where saved
Save settings
Default value
TCP
Default value
NONE
6-159