Display:<Function>:Digits - Keithley 2450 Reference Manual

Model 2450 Interactive SourceMeter® Instrument Reference Manual
:DISPlay:<function>:DIGits
This command determines the number of digits that are displayed for measurements on the front panel.
Type
Command and query
Usage
:DISPlay:<function>:DIGits <n>
:DISPlay:<function>:DIGits?
:DISPlay:<function>:DIGits? DEFault
:DISPlay:<function>:DIGits? MINimum
:DISPlay:<function>:DIGits? MAXimum
<function>
<n>
Details
This command affects how the reading for a measurement is displayed on the front panel of the instrument. It
does not affect the number of digits returned in a remote command reading. It also does not affect the accuracy
or speed of measurements.
The display digits setting is saved with the function setting, so if you use another function, then return to the
function for which you set display digits, the display digits setting you set previously is retained.
If you send this but do not define the function (:DISPlay:DIGits), the digits values for all functions
are changed.
Example
:DISP:CURR:DIG 5
Also see
None
2450-901-01 Rev. B/September 2013
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which this setting applies:
Current: CURRent[:DC]
•
Resistance: RESistance
•
Voltage: VOLTage[:DC]
•
3.5 digit resolution: 3
4.5 digit resolution: 4
5.5 digit resolution: 5
6.5 digit resolution: 6
Section 6: SCPI command reference
Where saved
Save settings
Measure configuration list
Set the front panel to display current
measurements with 5½ digits.
Default value
5
6-23