BONFIGLIOLI Vectron Active Cube User Manual page 54

A Value of a parameter is set via KP500 or VPlus. No "save" command.
1)
2)
3)
B No "save" command. The value of the CANopen
1)
2)
3)
4)
C "Save" command. The value of the CANopen
1)
2)
3)
4)
5)
D "Save" command. The value of the CANopen
corresponding parameter value has been changed after the "save" command.
1)
2)
3)
4)
5)
6)
* Internal conversion to a frequency value taking into account the
In this example the number of pole pairs is two (four-pole machine).
NOTE
There are inverter parameters calculated from CANopen
no. of pole pairs for calculating the corresponding value for inverter parameters (e.
g. deceleration or acceleration parameters). These calculations always use the no.
of pole pairs from data set 1. If the no. of pole pairs is different in the data sets, the
result of this operation will not be clear for the user. To avoid confusion it is recom-
mended to write the inverter parameters via the SDO channel using the
(manufacturer) objects and not to use the CANopen
encies are avoided.
All CANopen
in this manual.
54
Setting of
Maximum Frequency
Power OFF and ON.
The value of KP500/VPlus is active (48 Hz).
Setting of
Maximum Frequency
®
Setting of CANopen object
Power OFF and ON.
Parameter value of KP500/VPlus overwrites the value of the CANopen
object. The value of KP500/VPlus is active (48 Hz).
Setting of
Maximum Frequency
®
Setting of CANopen object
"Save" command via CANopen
Power OFF and ON.
®
The value of CANopen
Setting of
Maximum Frequency
®
Setting of CANopen object
"Save" command via CANopen
Setting of
Maximum Frequency
Power OFF and ON.
®
Value of CANopen object
®
value of CANopen object
®
DS402 objects with corresponding inverter parameters are pointed out
CM-CAN ACU
419 = 48 Hz at KP500 or in VPlus.
®
object is overwritten.
419 = 48 Hz at KP500 or in VPlus.
0x6046 = 1140 rpm* (equivalent to 38 Hz).
®
object is stored.
419 = 48 Hz at KP500 or in VPlus.
0x6046 = 1140 rpm* (equivalent to 38 Hz).
®
object 0x1010.
object 0x6046 is active (38 Hz).
®
object is stored – even if the
419 = 48 Hz at KP500 or in VPlus.
0x6046 = 1140 rpm* (equivalent to 38 Hz).
®
object 0x1010.
419 = 48 Hz at KP500 or in VPlus.
0x6046 overwrites the parameter value. The
0x6046 is active (38 Hz).
®
®
objects. This way, inconsist-
®
373.
No. of Pole Pairs
objects which require the
0x2nnn
04/13