Table of Contents
Advertisement
Command Mode
Interface Configuration, Interface range
User Guidelines
The VLAN must be configured on the interface is order to carry traffic. The
interface must be configured to carry tagged traffic (i.e., trunk mode).
MSRP must also be enabled globally in order to become operational.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example configure MSRP traffic on interface Gi1/0/2 for VLAN 12
console(config)#interface gi1/0/2
console(config-if-Gi1/0/2)#msrp
console(config-if-Gi1/0/2)#msrp srclass-pvid 12
msrp srclassqav
Use this command to configure the IEEE Qav class priority map. Use the no
form of the command set the class configuration to the default.
Syntax
msrp srclassqav class [a | b] [pcp | remap] 0-7
no msrp srclassqav class [ a | b ]
class a | b—Specifies the class to be configured. Dell EMC Networking
•
switches support class A and class B priorities.
•
pcp—Specifies the priority of the selected MSRP traffic class. The range is
0–7. This is the value received in the Ethernet frame for trusted ports or
assigned by the system as a default.
•
remap—Specifies the priority of the non-AVB traffic with AVB traffic class
PCP. The range is 0–7. This is the priority to which traffic is remapped.
Default Configuration
The defaults for the traffic classes are:
Audio Visual Bridging Commands
1097
Advertisement
Table of Contents
