Dot1As (Interface Configuration) - Dell N1100-ON Reference Manual

User Guidelines
IEEE 802.1AS propagates time information from master clocks and
synchronizes internally with the clock in support of delivering streams to the
destination device with the same relative timing as sampled at the source.
All IEEE 802.1AS interfaces must reside on the same stack member.
Propagation of timing information across a stack is not supported.
IEEE 802.1AS must also be enabled on individual interfaces to become
operational.
This command is only available on the N4000 Series switches.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config)#dot1as

dot1as (Interface Configuration)

Use this command to enable IEEE 802.1AS on an interface. Use the no form
of the command to disable IEEE 802.1AS on an interface.
Syntax
dot1as
no dot1as
Default Configuration
By default, IEEE 802.1AS is disabled globally and on all interfaces.
Command Mode
Interface Configuration
User Guidelines
IEEE 802.1AS propagates time information from master clocks and
synchronizes with the internal clock in support of delivering streams to the
destination device with the same relative timing as sampled at the source.
1111
Audio Visual Bridging Commands