Dot1As Interval Pdelay - Dell N1100-ON Reference Manual

Command History
Introduced in version 6.2.0.1 firmware.
Example
This example configures the switch with an initial log sync interval of 3.
console(config-if-Gi1/0/1)#dot1as interval sync 3
console(config-if-Gi1/0/1)#show dot1as interface gi1/0/1
AS Interface Admin Mode................... Enabled
AS Capable................................ No
Is Measuring Delay............................. No
Propagation Delay.............................. 0
Port Role...................................... Disabled
PDELAY Threshold............................... 2500
PDELAY lost responses allowed.................. 3
Neighbor Rate Ratio............................ 0
Initial Sync Interval.......................... 3
Current Sync Interval.......................... -3
Initial Pdelay Interval........................ 0
Current Pdelay Interval........................ 0
Initial Announce Interval...................... 3
Current Announce Interval...................... 0
Sync Receipt Timeout........................... 3
Announce Receipt Timeout....................... 3

dot1as interval pdelay

Use this command to configure the pdelay interval for an interface. Use the
no form of the command to return the pdelay interval to the default.
Syntax
dot1as interval pdelay int-val
no dot1as interval pdelay
• int-val—The initial pdelay interval in log base 2 format. The range is –5 to
5.
Default Configuration
By default, the pdelay interval is 0.
Audio Visual Bridging Commands
1116