M
I
ANAGEMENT
NTERFACE
3.3.8 SNMP
Configuration
The SNMP Community Configuration page allows users to configure community string
status and access mode. It also displays the settings for each community string status. To
access this page, click Management > SNMP > Configuration.
The following table describes the items in the previous menu.
Table 3-21. Management > SNMP > Configuration
Parameter
Community
Client IP Address
Client IP Mask
Access Mode
Status
Submit
Delete
62
Figure 3-23. Management > SNMP > Configuration
Click the drop-down menu to select a community name or select Create to create a
new one (up to 16 characters).
Enter the client IP address to allow SNMP clients using the community to access
the device.
NOTE: Access available for any IP addresses if IP address or IP mask is 0.0.0.0.
Enter the client IP mask to allow SNMP clients using the community to access the
device.
NOTE: Allow to access for only one IP if IP mask is 255.255.255.255.
Click the drop-down menu to specify the access level.
Click the drop-down menu to enable or disable community.
Click Submit to update the screen. To save the values across a power cycle per-
form a system save.
Click Delete to delete the selected community.
Description