Advantech EKI-9316P Series User Manual page 200

M I
ANAGEMENT NTERFACE
The following table describes the items in the previous menu.
Table 3-135. Multicast > MLD Snooping > VLAN Configuration
Parameter
VLAN ID
VLAN ID
Admin Mode
Fast Leave Admin
Mode
Group Membership
Interval
Maximum Response
Time
Multicast Router
Expiry Time
Submit
Delete
Multicast Router Status
The MLD Snooping Multicast Router Status displays the multicast router settings for each
interface. To access this page, click Multicast > MLD Snooping > Multicast Router
Status.
Figure 3-139. Multicast > MLD Snooping > Multicast Router Status
188
Click the drop-down menu to specify the list of VLAN IDs for which MLD Snooping
is enabled.
Enter a value for the VLAN ID. Appears when "New Entry" is selected in VLAN ID
combo box. Specifies VLAN ID for which pre-configurable Snooping parameters
are to be set.
Displays the MLD Snooping status for the specified VLAN ID.
Click the drop-down menu to enable or disable the MLD Snooping Fast Leave
Mode for the specified VLAN ID.
Enter the value for group membership interval of MLD Snooping for the specified
VLAN ID. Valid range is (Maximum Response Time + 1) to 3600.
Enter the value for maximum response time of MLD Snooping for the specified
VLAN ID. Valid range is 1 to (Group Membership Interval - 1). Its value should be
less than group membership interval value.
Enter the value for multicast router expiry time of MLD Snooping for the specified
VLAN ID. Valid range is 0 to 3600.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Click Delete to remove the switch with the default values.
Description