Advantech EKI-9316P Series User Manual page 152

M I
ANAGEMENT NTERFACE
The following table describes the items in the previous menu.
Table 3-89. Switching > Port Mirroring > Port Mirroring
Parameter
Session ID
Mode
Destination Port
Direction
Source Port(s)
Add Source Port
Remove Source Port Click Remove Source Port to remove a configured Source Port(s) of the selected
Submit
Delete
The Add Source Port allows users to add source ports and configure the
direction for each session ID.
Figure 3-93. Switching > Port Mirroring > Port Mirroring > Add Source Ports
140
Click the drop-down menu to select a port mirroring session from the list. The num-
ber of sessions allowed is platform specific. By default the First Session is
selected.
Click the drop-down menu to enable or disable the Session Mode for a selected
session ID. The default Session Mode is disabled.
Click the drop-down menu to select the destination port and receive all the traffic
from configured mirrored port(s). Default value is None.
Displays the direction of traffic on source port(s) which will be sent to the probe
port. Possible values are:
Tx and Rx - Both Ingress and Egress traffic.

 Rx - Ingress traffic only.
 Tx - Egress traffic only.
Displays the source port(s) with directions as mirrored port(s). Traffic of the source
port(s) is sent to the probe port.
Up to 16 source ports can be selected per session.
Click Add Source Port to add Source Port(s) to the selected session.
session.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Click Delete to remove the selected session configuration.
Description