Advantech EKI-9316P Series User Manual page 273

The following table describes the items in the previous menu.
Table 3-206. QoS > Class of Service > Interface Queue Configuration
Parameter
Interface
Minimum Bandwidth
Allocated
Queue ID
Minimum Bandwidth
Maximum Bandwidth Enter a value to specify the maximum bandwidth allowed for this queue, typically
Scheduler Type
Queue Management
Type
Restore Defaults for
All Queues
Submit
Click the drop-down menu to select the CoS configurable interfaces. The option
"Global" represents the most recent global configuration settings. These may be
overridden on a per-interface basis.
Enter a value to the sum of individual Minimum Bandwidth values for all queues in
the interface. The sum cannot exceed the defined maximum of 100. This value is
considered while configuring the Minimum Bandwidth for a queue in the selected
interface.
Specifies all the available queues per interface (platform based).
Specifies the minimum guaranteed bandwidth allotted to this queue. Setting this
value higher than its corresponding Maximum Bandwidth automatically increases
the maximum to the same value. Default value is 0. Valid Range is 0 to 100 in
increments of 1. The value 0 means no guaranteed minimum. Sum of individual
Minimum Bandwidth values for all queues in the selected interface cannot exceed
defined maximum 100.
used to shape the outbound transmission rate. This value can be set to 0 without
regard to its corresponding Minimum Bandwidth, but cannot otherwise be set less
than the Minimum Bandwidth. The value 0 means maximum is unlimited. Default
value is 0. Valid Range is 0 to 100 in increments of 1.
Click the drop-down menu to set the type of scheduling used for this queue. Sched-
uler Type can only be one of the following:
strict

weighted

NOTE: Default value is weighted.
Click the drop-down menu to set the queue depth management technique used for
queues on this interface. This is only used if device supports independent settings
per-queue. Queue Management Type can only be one of the following:
taildrop

NOTE: Default value is taildrop.
Click Restore Defaults for All Queues to restore default settings for all queues on
the selected interface.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
M
ANAGEMENT
Description
I
NTERFACE
261