Advantech EKI-9316P Series User Manual page 108

M I
ANAGEMENT NTERFACE
Interface Configuration
Interface Configuration allows the selection of configurable ports supporting LLDP-MED
ports, the enabling of LLDP-MED mode and notification mode in addition to selecting of
TLV type value lengths.
To access this page, click Management > LLDP > LLDP-MED > Interface Configuration.
Figure 3-57. Management > LLDP > LLDP-MED > Interface Configuration
The following table describes the items in the previous menu.
Table 3-55. Management > LLDP > LLDP-MED > Interface Configuration
Parameter
Interface
LLDP-MED Mode
Config Notification
Mode
Transmit TLVs
Submit
Interface Status
Interface Status displays a summary of non-configurable data for the LLDP-MED function.
96
Click the drop-down menu to select the LLDP-MED - 802.1ab interface to config-
ured. 'All' option is provided to configure all interfaces on the DUT and to be consis-
tent with CLI. To view the summary of all interfaces refer to 'Interface Summary'
webpage. Interface configuration page will not be able to display summary of 'All'
interfaces, summary of individual interfaces is visible from 'Interface Configuration'
webpage. 'Interface Configuration' webpage for 'All' option will always display
LLDP-MED mode and notification mode as 'disabled' and checkboxes for 'Transmit
TLVs' will always be unchecked.
Click the drop-down menu to enable or disable the Link Layer Discovery Protocol-
Media Endpoint Discovery(LLDP-MED) mode for the selected interface. By
enabling MED, we will be effectively enabling the transmit and receive function of
LLDP.
Click the drop-down menu to enable or disable the LLDP-MED topology notification
mode for the selected interface.
Click an option to select a type length values (TLVs) in the LLDP-MED will be trans-
mitted in the LLDP PDUs frames for the selected interface.
MED Capabilities - To transmit the capabilities TLV in LLDP frames.

Network Policy - To transmit the network policy TLV in LLDP frames.

Click Submit to update to the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Description