Mac Access Control Lists - Advantech EKI-9316P Series User Manual

M I
ANAGEMENT NTERFACE
Table 3-184. QoS > Access Control Lists > IPv6 Access Control Lists > Rule
Configuration (Continued)
Parameter
Flow Label
IPv6 DSCP Service
Configure
Delete
Submit
Cancel

MAC Access Control Lists

Configuration
The Configuration page allows users to configure settings for existing MAC ACLs or create
new ones. To access this page, click QoS > Access Control Lists > MAC Access
Control Lists > Configuration.
Figure 3-188. QoS > Access Control Lists > MAC Access Control Lists > Configuration
240
Enter a label is 20-bit number that is unique to an IPv6 packet, used by end sta-
tions to signify quality-of-service handling in routers. Flow label can specified within
the range 0 to 1048575.
Enter the IP DiffServ Code Point (DSCP) field. The DSCP is defined as the high-
order six bits of the Service Type octet in the IPv6 header. This is an optional con-
figuration. Enter an integer from 0 to 63. The IPv6 DSCP is selected by possibly
selection one of the DSCP keyword from a drop-down box. If a value is to be
selected by specifying its numeric value, then select the 'Other' option in the drop-
down box and a text box will appear where the numeric value of the DSCP can be
entered.
Click Configure to setup the corresponding match criteria for the selected rule.
Click Delete to remove the currently selected Rule from the selected ACL. These
changes will not be retained across a power cycle unless a save configuration is
performed.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
This button is shown when you are configuring individual match conditions.
Click Cancel to discard the changes made on the page.
Description