Source Interface Configuration; Community; Figure 4.48 System > Advanced Configuration > Snmp Community - Advantech EKI-9516P-HV User Manual

Source Interface Configuration

Use the sFlow Source Interface Configuration page to specify the physical or logical
interface to use as the sFlow client source interface. When an IP address is config-
ured on the source interface, this address is used for all sFlow communications
between the local sFlow client and the remote sFlow server. The IP address of the
designated source interface is used in the IP header of sFlow management protocol
packets. This allows security devices, such as firewalls, to identify all source packets
coming from a specific device.
To access this page, click System > Advanced Configuration > sFlow > Source
Interface Configuration.
Figure 4.47 System > Advanced Configuration > sFlow > Source Interface
The following table describes the items in the previous figure.
Item
Type
Interface
VLAN ID
Submit
Refresh
Cancel
4.3.2.8 SNMP

Community

Access rights are managed by defining communities on the SNMPv1, 2 Community
page. When the community names are changed, access rights are also changed.
SNMP Communities are defined only for SNMP v1 and SNMP v2.
Use the SNMP Community Configuration page to enable SNMP and Authentication
notifications.
To access this page, click System > Advanced Configuration > SNMP > Commu-
nity.
Figure 4.48 System > Advanced Configuration > SNMP > Community
Configuration
Description
The type of interface to use as the source interface:

None: The primary IP address of the originating (outbound)
interface is used as the source address.

Interface: The primary IP address of a physical port is used as
the source address.

VLAN: The primary IP address of a VLAN routing interface is
used as the source address.
When the selected Type is Interface, select the physical port to use as
the source interface.
When the selected Type is VLAN, select the VLAN to use as the
source interface. The menu contains only the VLAN IDs for VLAN
routing interfaces.
Click Submit to save the values and update the screen.
Click Refresh to update the screen.
Click Cancel to restore default value.
59 EKI-9500 Series User Manual