Global Status - Advantech EKI-9316P Series User Manual

Table 3-101. Switching > QinQ > Global Configuration (Continued)
Parameter
Global EtherType
Custom Value
Submit
Remove

Global Status

The DVLAN Summary page displays information for each TPID. To access this page, click
Switching > QinQ > Global Status.
The following table describes the items in the previous menu.
Table 3-102. Switching > QinQ > Global Status
Parameter
Global TPIDs
Primary TPID
Refresh
Interface Configuration
The DVLAN Interface Configuration page allows users to enable or disable settings for
each interface. To access this page, click Switching > QinQ > Interface Configuration,
Figure 3-106. Switching > QinQ > Interface Configuration
Click the drop-down menu to specify the global EtherType available. The two-byte
hex EtherType to be used as the first 16 bits of the DVLAN tag.
 802.1Q Tag - Commonly used tag representing 0x8100.
vMAN Tag - Commonly used tag representing 0x88A8.

Custom Tag - Configure the tag for EtherType by providing a custom value.

Enter the value to assign the custom tag in any range from 1 to 65535.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Click Remove to deletes the selected Global Ether Type.
Figure 3-105. Switching > QinQ > Global Status
Displays the Global tag protocol identifiers (TPIDs) configured.
Displays the Primary tag protocol identifier (TPID) configured.
Click Refresh to update the data on the screen with the present state of the data in
the switch.
M
ANAGEMENT
Description
Description
I
NTERFACE
153