Advantech EKI-9316P Series User Manual page 107

The following table describes the items in the previous menu.
Table 3-53. Management > LLDP > Remote Device Summary
Parameter
Interface
Remote ID
Chassis ID
Port ID
System Name
Refresh
Clear
LLDP-MED
Global Config
Global Configuration allows users to specify the number of LLDP PDUs that can be trans-
mitted when the protocol is enabled.
To access this page, click Management > LLDP > LLDP-MED > Global Config.
Figure 3-56. Management > LLDP > LLDP-MED > Global
Config The following table describes the items in the previous menu.
Table 3-54. Management > LLDP > LLDP-MED > Global Config
Parameter
Fast Start Repeat
Count
Device Class
Submit
Displays the local port which can receive LLDP frames advertised by a remote sys-
tem.
Displays the remote client identifier assigned to the remote system.
Displays the chassis component associated with the remote system.
Displays the port component associated with the remote system.
Displays the system name of the remote system.
Displays the data on the screen with the present state of the data in the switch.
Click Clear to refresh LLDP Remote Device information received on all the inter-
faces.
Enter the number of LLDP PDUs that will be transmitted when the protocol is
enabled. The range is from 1 to 10. Default value of fast repeat count is 3.
Displays the local device's MED Classification. There are four different kinds of
devices, three of them represent the actual end points (classified as Class I
Generic [IP Communication Controller etc.], Class II Media [Conference Bridge
etc.], Class III Communication [IP Telephone etc.]). The fourth device is Network
Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge,
IEEE 802.11 Wireless Access Point etc.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
M
ANAGEMENT
Description
Description
I
NTERFACE
95