Advantech EKI-9316P Series User Manual page 251

Table 3-184. QoS > Access Control Lists > IPv6 Access Control Lists > Rule
Configuration (Continued)
Parameter
Source Prefix/Prefix-
Length
Source L4 Port
Source L4 Port
Range (start port)
Source L4 Port
Range (end port)
Destination Prefix/
PrefixLength
Destination L4 Port
Keyword
Destination L4 Port
Number
Destination L4 Port
Range (start port)
Destination L4 Port
Range (end port)
Enter a value to specify the IPv6 Prefix--combined with IPv6 Prefix length of the
network or host from which the packet is being sent. Prefix length can be in the
range 0 to 128.
Enter a value to specify a packet's source layer 4 port as a match condition for the
selected IPv6 ACL rule. Source port information is optional. Source port informa-
tion can be specified in two ways:
 Select keyword "other" from the drop down menu and specify the number of the
port in the range from 0 to 65535.
Select one of the keyword from the list: DOMAIN, ECHO, FTP, FTPDATA,

HTTP, SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values trans-
lates into its equivalent port number, which is used as both the start and end of
the port range.
Enter a value to specify the first port of the port range for a packet's source layer 4
port match condition for the selected IPv6 ACL rule. Range of valid values is 0 to
65535. The value of the start port must be less than or equal to the end port. The
start port, end port, and all ports in between will be part of the contiguous source
port range. This is an optional configuration.
Enter a value to specify the last port of the port range for a packet's source layer 4
port match condition for the selected IPv6 ACL rule. Range of valid values is 0 to
65535. The value of the end port must be greater than or equal to the start port.
The start port, end port, and all ports in between will be part of the contiguous
source port range. This is an optional configuration.
Enter up to 128-bit prefix combined with prefix length to be compared to a packet's
destination IP Address as a match criteria for the selected IPv6 ACL rule. Prefix
length can be in the range 0 to 128.
Enter a value to specify the destination layer 4 port match conditions for the
selected IPv6 ACL rule. The possible values are DOMAIN, ECHO, FTP, FTPDATA,
HTTP, SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values translates
into its equivalent port number, which is used as both the start and end of the port
range. Either this field or the 'Destination L4 Port Range' fields can be used to
specify a destination layer 4 port range as a match criterion. This is an optional
configuration.
Enter a packet's destination layer 4 port number match condition for the selected
IPv6 ACL rule. This is an optional configuration.
Enter a packet's destination layer 4 port match condition for the selected IPv6 ACL
rule. This field identifies the first port of the port range and has a value from 0 to
65535. The value of the start port must be less than or equal to the end port. The
start port, end port, and all ports in between will be part of the contiguous source
port range. This is an optional configuration.
Enter a packet's destination layer 4 port match condition for the selected IPv6 ACL
rule. This field identifies the last port of the port range and has a value from 0 to
65535. The value of the end port must be greater than or equal to the start port.
The start port, end port, and all ports in between will be part of the contiguous
source port range. This is an optional configuration.
M
ANAGEMENT
Description
I
NTERFACE
239