Advantech EKI-9316P Series User Manual page 234

M I
ANAGEMENT NTERFACE
Interface Configuration
The DHCP L2 Relay Interface Configuration page allows users to enable or disable the
DHCP L2 relay mode and relay trust mode for each interface. To access this page, click
Security > DHCP Snooping > DHCP L2 Relay > Interface Configuration.
Figure 3-171. Security > DHCP Snooping > DHCP L2 Relay > Interface Configuration
The following table describes the items in the previous menu.
Table 3-168. Security > DHCP Snooping > DHCP L2 Relay > Interface
Configuration
Parameter
Interface
DHCP L2 Relay
Mode
DHCP L2 Relay
Trust Mode
Submit
Refresh
VLAN Configuration
The DHCP L2 Relay VLAN Configuration page allows users to enable or disable DHCP
L2 relay mode and circuit ID, and assign a remote ID for each VLAN ID. To access this
page, click Security > DHCP Snooping > DHCP L2 Relay > VLAN Configuration.
Figure 3-172. Security > DHCP Snooping > DHCP L2 Relay > VLAN Configuration
222
Click the drop-down menu to select the interface for which data is to be displayed
or configured.
Click the drop-down menu to enable or disable L2 Relay mode on selected inter-
face. The factory default is Disable.
Click the drop-down menu to enable or disable the L2 relay. If this is Enabled,
DHCP L2 Relay application considers selected port as L2 Relay trusted. The fac-
tory default is Disable.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Click Refresh to update the data on the screen with the present state of the data in
the switch.
Description