X-Ring Pro - Advantech EKI-9316P Series User Manual

M I
ANAGEMENT NTERFACE
Table 3-109. Switching > Port Channel > Status (Continued)
Parameter
Load Balance
Refresh

3.4.9 X-Ring Pro

Configuration
The X-Ring Pro Configuration page allows users to configure the settings for each ring ID.
To access this page, click Switching > X-Ring Pro > Configuration.
The following table describes the items in the previous menu.
Table 3-110. Switching > X-Ring Pro > Configuration
Parameter
Ring ID
Mode
Interface 1
162
Displays the Load balance policy of the Port Channel. The possible values are:
 Source MAC, VLAN, Ethertype, and source port
 Destination MAC, VLAN, EtherType and source port
Source/Destination MAC, VLAN, Ethertype, and source port

Source IP and Source TCP/UDP Port

 Destination IP and Destination TCP/UDP Port
 Source/Destination IP and source/destination TCP/UDP Port
Click Refresh to update the data on the screen with the present state of the data in
the switch.
Figure 3-113. Switching > X-Ring Pro > Configuration
Specifies a number ranging from 1 to 99 to identify a given X-Ring group.
Click the drop-down menu to select the mode of the X-Ring group. The value is
either "Ring" or "Coupling". The default value is "Ring".
The X-Ring group denoted as mode "Ring" means this switch is connected to

the other switches to form a ring topology.
 The X-Ring group denoted as "Coupling" means this switch is used to inter-
connect two X-Ring networks.
Click the drop-down menu to select the first member interface for the X-Ring group.
The value is either physical port or LAG (Link-Aggregation-Group) port.
Description
Description