Advantech EKI-9316P Series User Manual page 250

M I
ANAGEMENT NTERFACE
The following table describes the items in the previous menu.
Table 3-184. QoS > Access Control Lists > IPv6 Access Control Lists > Rule
Configuration
Parameter
IPv6 ACL Name
Rule
Rule ID
Action
Logging
Assign Queue ID
Mirror Interface
Redirect Interface
Match Every
Protocol
238
Click the drop-down menu to select the IPv6 ACL for which to create or update a
rule.
Click the drop-down menu to select an existing rule from the pull-down menu or
select 'Create New Rule.' New rules cannot be created if the maximum number of
rules has been reached. For each rule, a packet must match all the specified crite-
ria in order to be true against that rule and for the specified rule action (Permit/
Deny) to take place.
Enter a whole number in the range of 1 to 1023 that will be used to identify the rule.
Click the drop-down menu to select the policy (permit or deny).
Click the drop-down menu to enable or disable the logging function. If the Access
List Trap Flag is also enabled, this will cause periodic traps to be generated indicat-
ing the number of times this rule was 'hit' during the current report interval. A fixed
5 minute report interval is used for the entire system. A trap is not issued if the ACL
rule hit count is zero for the current interval.
Enter a value to specify the hardware egress queue identifier used to handle all
packets matching this IPv6 ACL rule. Valid range of Queue IDs is 0 to 7. This field
is visible for a 'Permit' Action.
Displays the specific egress interface where the matching traffic stream is copied in
addition to being forwarded normally by the device. This field cannot be set if a
Redirect Interface is already configured for the ACL rule. This field is visible for a
'Permit' Action.
Displays the specific egress interface where the matching traffic stream is forced,
bypassing any forwarding decision normally performed by the device. This field
cannot be set if a Mirror Interface is already configured for the ACL rule. This field
is visible for a 'Permit' Action.
Click the drop-down menu to select the matching rule. True signifies that all pack-
ets will match the selected IPv6 ACL and Rule and will be either permitted or
denied. In this case, since all packets match the rule, the option of configuring other
match criteria will not be offered. To configure specific match criteria for the rule,
remove the rule and re-create it, or re-configure 'Match Every' to 'False' for the
other match criteria to be visible.
Enter a value to configure IPv6 protocol.
Specify an integer ranging from 0 to 255 after selecting protocol keyword

"other". This number represents the IP protocol.
 Select name of a protocol from the existing list of Internet Protocol (IP), Trans-
mission Control Protocol (TCP), User Datagram Protocol (UDP), Internet Con-
trol Message Protocol (ICMP) and Internet Group Management Protocol
(IGMP).
Description