Advantech EKI-9316P Series User Manual page 255

Table 3-187. QoS > Access Control Lists > MAC Access Control Lists > Rule
Configuration (Continued)
Parameter
CoS
Secondary CoS
Destination MAC
Destination MAC
Mask
Ethertype Key
Ethertype User Value Click Configure and enter the Ethertype value (between 0x0600 to 0xFFFF) when
Source MAC
Source MAC Mask
VLAN Range
From
To
VLAN
Secondary VLAN Range
Click Configure and enter the 802.1p user priority (between 0 to 7) to compare
against an Ethernet frame.
Click Configure and enter the secondary 802.1p user priority (between 0 to 7) to
compare against an Ethernet frame.
Click Configure and enter the MAC address (XX:XX:XX:XX:XX:XX) to compare
against an Ethernet frame.
Click Configure and enter the MAC mask address (XX:XX:XX:XX:XX:XX) to com-
pare against an Ethernet frame.
Click Configure and click the drop-down menu to select the ethertype value.
The options are:
Appletalk

ARP

IBM SNA

IPv4

IPv6

IPX

MPLS multicast

MPLS unicast

NetBIOS

Novell

PPPoE

Reverse ARP

User Value

Ethertype Key is User Value.
Click Configure and enter the MAC address (XX:XX:XX:XX:XX:XX).
Click Configure and enter the MAC mask address (XX:XX:XX:XX:XX:XX).
Click Configure and enter the VLAN ID (between 0 to 4095) to compare against an
Ethernet frame.
Click Configure and enter the VLAN ID (between 0 to 4095) to compare against an
Ethernet frame.
Click Configure and enter the VLAN ID (between 0 to 4095) to compare against an
Ethernet frame.
M
ANAGEMENT
Description
I
NTERFACE
243