Advantech EKI-9316P Series User Manual page 135

Table 3-81. Switching > Interface Setting > Configuration (Continued)
Parameter
Broadcast Storm
Recovery Mode
Broadcast Storm
Recovery Level
Multicast Storm
Recovery Mode
Multicast Storm
Recovery Level
Unicast Storm
Recovery Mode
Unicast Storm
Recovery Level
LACP Mode
Physical Mode
Physical Status
Click the drop-down menu to enable or disable this option by selecting the corre-
sponding line on the pull-down entry field. When you specify Enable for Broadcast
Storm Recovery and the broadcast traffic on the specified Ethernet port exceeds
the configured threshold, the switch blocks (discards) the broadcast traffic. The fac-
tory default is Disable.
Enter a value to specify the data rate at which storm control activates. The factory
default is 5 percent of port speed. The level units can be set to percent or packets-
per-second. The range of Broadcast Storm Recovery Level in packets-per-second
is 0 to 1488000.
Click the drop-down menu to enable or disable this option by selecting the corre-
sponding line on the pull-down entry field. When you specify Enable for Multicast
Storm Recovery and the multicast traffic on the specified Ethernet port exceeds the
configured threshold, the switch blocks (discards) the multicast traffic. The factory
default is Disable.
Enter a value to specify the data rate at which storm control activates. The factory
default is 5 percent of port speed. The level units can be set to percent or packets-
per-second. The range of Multicast Storm Recovery Level in packets-per-second is
0 to 1488000.
Click the drop-down menu to enable or disable this option by selecting the corre-
sponding line on the pull-down entry field. When you specify Enable for Unicast
Storm Recovery and the unicast traffic on the specified Ethernet port exceeds the
configured threshold, the switch blocks (discards) the unicast traffic. The factory
default is Disable.
Enter a value to specify the data rate at which storm control activates. The factory
default is 5 percent of port speed. The level units can be set to percent or packets-
per-second. The range of Unicast Storm Recovery Level in packets-per-second is
0 to 1488000.
Click the drop-down menu to select the Link Aggregation Control Protocol adminis-
tration state. The mode must be enabled in order for the port to participate in Link
Aggregation. May be enabled or disabled by selecting the corresponding line on
the pull-down entry field. The factory default is Enable.
Click the drop-down menu to select the port's speed and duplex mode. If you select
auto the duplex mode and speed will be set by the auto-negotiation process. Note
that the port's maximum capability (full duplex and 100 Mbps) will be advertised.
Otherwise, your selection will determine the port's duplex mode and transmission
rate. The factory default is Auto. The selection when applied against the "All" option
in Slot/Port is applied to all applicable interfaces only.
Displays the physical status.
Normal - the port is a normal port.

Trunk Member - the port is a member of a Link Aggregation trunk. Look at the

LAG screens for more information.
Mirrored - the port is a mirrored port.

 Probe - the port is a monitoring port. Look at the Port Monitoring screens for
more information.
M
ANAGEMENT
Description
I
NTERFACE
123