Advantech EKI-9316P Series User Manual page 205

VLAN Configuration
The MLD Snooping Querier VLAN Configuration page allows users to configure MLD
Snooping Querier VLAN settings. To access this page, click Multicast > MLD
Snooping Querier > VLAN Configuration.
Figure 3-145. Multicast > MLD Snooping Querier > VLAN Configuration
The following table describes the items in the previous menu.
Table 3-142. Multicast > MLD Snooping Querier > VLAN Configuration
Parameter
VLAN ID
VLAN ID
Querier Election Par- Click the drop-down menu to enable or disable the MLD Snooping Querier partici-
ticipate Mode
Snooping Querier
VLAN Address
Submit
Delete
Refresh
Click the drop-down menu to select an existing configuration or create a new one.
Enter a value for the VLAN ID. Appears when "New Entry" is selected in VLAN ID
selection list. Specifies VLAN ID for which MLD Snooping Querier is to be enabled.
User can also set pre-configurable Snooping Querier parameters.
pate. When this mode is disabled, up on seeing other querier of same version in
the VLAN, the snooping querier move to non-querier state. Only when this mode is
enabled, the snooping querier will participate in querier election where in the least
IP address will win the querier election and operates as the querier in that VLAN.
The other querier moves to non-querier state.
Enter the Snooping Querier Address to be used as source address in periodic MLD
queries sent on the specified VLAN.
Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Click Delete to remove a Snooping Querier on the selected VLAN. This button is
not visible when a VLAN is not selected.
Click Refresh to update the data on the screen with the present state of the data in
the switch.
M
ANAGEMENT
Description
I
NTERFACE
193