Install A Sas Drive - Oracle netra X5-2 Service Manual

Overheating hazard. There must be no empty drive slots.
Caution -
Related Information
"Locate a Faulty Drive" on page 95
■
"Install a SAS Drive" on page 99
■
"Preparing for Service" on page 61
■
"Returning the Server to Operation" on page 247
■

Install a SAS Drive

Installing a SAS drive is a hot-plug operation. You do not need to power off the server before
installing the drive. This procedure is the same for installing a drive filler panel.
1. Consider your first step.
If you are replacing a drive, remove the faulty or obsolete drive first, then return to this
■
procedure,
If you are installing a new or an additional drive, go to
■
If you are installing a drive as part of another component's removal or installation
■
procedure, go to
2. Review this information and complete these prerequisites in this order.
"Preparing for Service" on page 61
■
"SAS Drive Configuration" on page 94
■
"Remove the Filter" on page 89
■
3. Push the release button of the drive.
The release lever pops out.
Step 3. See "Remove a SAS Drive" on page
Step 3.
Install a SAS Drive
97.
Step 2.
Servicing SAS Drives 99