Diagnostic Information And Procedure; Ignition System - Daewoo MATIZ Service Manual

1E – 10 ENGINE ELECTRICAL

DIAGNOSTIC INFORMATION AND PROCEDURE

Condition
No Crank
Crank OK, But Too Slow
Starter Motor Does Not Stop
Starter Motor Running, But Not
Cranking
Overcharging Battery
Battery Discharge
Charging Indicator Lamp
Does Not Work When the
Ignition Switch ON
(Engine Does Not Work)
Charging Indicator Lamp
Does Not Put Out Lights After
Starting the Engine

IGNITION SYSTEM

Probable Cause
D Low battery voltage.
D Battery cable is loose, corroded,
or damaged.
D Faulty starter motor or starter
motor circuit is open.
D Faulty ignition switch or fuse Ef2
is blown.
D Ground short.
D Low battery voltage.
D Batter.
D Battery cables is loose, corroded,
or damaged.
D Faulty starter motor.
D Faulty starter motor.
D Faulty ignition switch.
D Broken the clutch pinion gear or
faulty starter motor.
D Broken the flywheel ring gear.
D Connected circuit is open.
D Faulty the IC regulator.
D Loosen the generator drive belt.
D The circuit is open or a short.
D Faulty IC regulator.
D Battery run down.
D Open ground circuit.
D Fault IC regulator.
D Charging indicator lamp is blown
or fuse F8 is blown.
D Faulty ignition switch.
D Generator ground circuit is open
or a short.
D Faulty IC regulator.
D Battery cable is corroded or
damaged.
D Loosen the generator drive belt.
D Faulty wiring harness.
Correction
D Charging the battery or Replace
the battery.
D Repair or Replace the battery
cable.
D Repair or Replace the starter
motor/starter motor circuit.
D Replace the ignition switch or fuse
Ef2.
D Repair the ground short.
D Charging the battery or Replace
the battery.
D Repair or Replace the battery
cable.
D Repair or Replace the starter
motor.
D Repair or Replace the starter
motor.
D Replace the ignition switch.
D Replace the starter motor.
D Replace the flywheel.
D Repair the open circuit.
D Replace the IC regulator.
D Adjust the belt tension or Replace
the belt.
D Repair the open or a short circuit.
D Replace the IC regulator.
D Replace the battery.
D Repair the open ground circuit.
D Replace the IC regulator.
D Repair or Replace the charging
indicator lamp/fuse F8.
D Replace the ignition switch.
D Repair the circuit.
D Replace the IC regulator.
D Repair or Replace the battery
cable.
D Adjust the belt tension or Replace
the belt.
D Repair the wiring harness.
DAEWOO M-150 BL2