Daewoo MATIZ Service Manual page 162

1F – 64 ENGINE CONTROLS
DTC P0108 – Manifold Absolute Pressure Sensor High Voltage (Cont'd)
Step
1. Replace the manifold absolute pressure sensor.
2. Clear any DTCs from the ECM.
11
3. Perform the diagnostic system check.
Is the replacement complete?
Replace the ECM.
12
Is the replacement complete?
Check if any additional DTCs are set.
13
Are any DTCs displaced that have not been
diagnosed?
Action Value(s) Yes
–
System OK
–
Go to Step 13
Go to
applicable DTC
–
table
No
–
Go to Step 2
System OK
DAEWOO M-150 BL2